My 3900X is now failing and given Roku's habit of buggy firmware, I wonder if firmware 13.0.0 (Build 24056) may be to blame. Anyone else having this issue?
Start watching something and a short time in it just stops. I'm suddenly offline. Go to setup, set up connection, wireless, and NO wifi sources are shown where there would normally be a half dozen or more. Cycle that page a few times but nada. NO Wifis.
Power cycle the Roku. Sometimes it will come back the same way, with no wifi sources. Otherwise if it comes back in a normal state, it reconnects and no manual action is needed. It does this all the time now. But I don't think it enters this state when not actively viewing. I usually leave it back on menu before going off turning off the tv or viewing a non Roku source and upon going back to Roku it will still be online at that point so seems related to actually viewing a stream.
---
Yes, they have horrible firmware. I once had a fairly new one update and could then no longer go online. They sent me a replacement. I connected it to wifi, it checked for a firmware update, downloaded, rebooted, and could no longer connect. They had introduced a bug that made it incompatible with my WiFi. They told me to get a new router. Some sort of intentional security requirement for my own protection? No. Because I discovered some updates later that the Roku device became compatible once again with the older type router so if it was an important security requirement that would not have been done. It was a bug pure and simple.
It can be taken as a given that any new release of an OS will contain bugs. It really shouldn't, but it is what it is nowadays.
However, the device you have (3900 Express), although still supported by Roku is a bit light on the memory resources available (512mb) while many of these channels/app have gotten a bit more resource hungry and the Roku OS a bit more bloated.
The last couple of software updates seem focused on memory management to allow more of the devices to still run, but there comes a time when an upgrade is necessary so your device can just work without having to struggle to keep up.
As for the network issues, the older Roku devices (like the 3900 and other 2.4ghz-only devices) ran into issues with some ISP (internet service providers) that were limiting/disabling legacy protocols on their networks so users needed to have to configure their routers to use b/g/n on those affected. (some may have indicated for security reasons, but inaccurate, and was implemented by ISP simply to preserve their "health" of their networks.)
----
It may just be time to bite the bullet and buy one of the newer Roku devices like the Express 4k+ (3941) which is currently on sale for $30. The newer Express 3960 HD is on sale for $20, but for the extra $10 you get a better device and a better remote. https://www.roku.com/products/players
All the newer devices are now dual band (2.4ghz and 5ghz), and have enough memory capabilities to run the OS and the channels/apps.
I personally just retired an older RokuTV that was struggling and increasingly giving me issues. There just comes a time when an upgrade is the easiest approach.
Just checked the wireless speed on my TCL Roku 50S535. It was usually in the 180s. Now it's in the 80s. This is after the update to 13.0.0 24056. My Roku Ultra, sitting next to the TV is running the same update and is getting 231. I have a network with three TP-Link routers with two as AP. The one next to this TV and the Ultra is an AX model as an AP. I did try connecting to another AX router and got the same result.
Looks like the TCL Roku update is a bit different from the Roku device update. Anyone else seeing this?
Hi, @tsesee @filmteknik
Thanks for posting here in the Roku Community.
We understand the changes in the network speed on your Roku TV after the Roku update, and we appreciate you for bringing this matter to our attention. For this matter, we'd like to collect further details regarding the issue so our team can review this case, and an investigation will be conducted.
Kindly provide the details below:
Once we have the requested information, our team will promptly work on the issue and take all necessary actions to address it.
Your response would be much appreciated.
Best wishes,
Kash
Thanks for replying. Here's all the info I could find. I hope it's what you need.
50S535 A118X
X003003A9C42
S05My0AA9C42
13.0.0 24062-88
11.6.21
Issue 42-226-144
That's everything I could find. Hope it helps.
Thanks for keeping us posted, @tsesee
Please be advised that we have forwarded your concern to the appropriate Roku team for your concern to be reviewed and further investigated. This will worked on, and will be handled accordingly.
In the meantime, we recommend following the steps below to address the issue.
Restart your Roku TV
Restart your network connection
After the network reset is done, your Roku device will restart and you will need to return to the Settings menu and set up your wireless network again. It is also recommended to restart your network modem/router for better results.
For more information, you can be guided by this support article on How to improve the Wi-Fi or wireless internet connection to your Roku streaming device
We hope for your patience as we work on the issue, and let us know if the steps provided above helps.
Best wishes,
Kash
Thanks for those steps, I will try them and if I still face this issue, I will update you by starting my own thread.
I am now completely baffled. I was going to perform the steps you provided (Thank You BTW). I decided to check the connection before doing so. It's now running at the correct speed. I checked the Update status and it hasn't changed (6/4 last update). I then checked the uptime to see if there was a restart: Nope, uptime was 8 days. The only thing I can attribute it to is doing the steps to get the info you asked for. So, that problem is solved for me but I have no other idea how it may have happened . Roku Magic!
FYI. I'm not a novice at all this. Although I'm 83 and long retired, I had a long career in the IT field including Network Admin for two companies, owned my own consulting firm and wrote custom software, and was a traveling technical advisor for a major consulting firm. None of which helped me solve this problem.
Thanks again for your time and help.