Same problem.. After update the Roku Ultra never goes into sleep mode after the TV is turned off. The light stays on..
I have taken to unplugging it to prevent heat damage and excess power supply use.
Strangely enough the light will go out if the TV is left on and the Roku goes to screen saver.
I have already replaced the power supply once and found that it was cheaper and faster to just buy one than replace it under warranty due to the fact that support insisted I had to mail them the entire unit instead of just sending me a replacement even though it was still under warranty at that time.
Model 4800X S/N X01000NM19PU Software version 11.50 Build 4216-C2
Device ID S02A20CM19PU
Hi @RoyElam,
Thanks for the post and for providing the information.
We apologize for the inconvenience this has caused, I have passed along your information to our team. Please be aware that this issue is still under investigation by the appropriate Roku team. Once more information is available, I'll update this Community thread.
We appreciate your patience while we investigated this issue.
Best regards,
Mary
Just a reminder (since always have new users to Roku), that you need to press the Home Button when you are finished streaming. This will stop all streaming, eventually activate screensaver, and allow device to eventually enter Sleep Mode.
Otherwise, you are relying on Auto Power Savings and Bandwidth Saver settings (if enabled) to stop the streaming and then enter Sleep Mode.
Pressing the Power button on your Roku remote only affects the TV, not the Roku device. (Power and volume buttons are TV controls only).
As I said, just a reminder and something to eliminate as a possible culprit.
After a little testing I found that if you turn off the screen saver in settings the Roku will go into sleep mode as it should (With the TV off).
Other changes I have noticed with this software update is when my Fubo app is selected it starts up on the top of the TV guide instead of on the last channel used, the volume comes on at zero and apps on the home screen don’t always show as selected (ring of light around the icon).
Verified last night and this morning: Turning off the screensaver in settings allowed the Roku sleep function to work as it should.
The power light goes out.
Disabling screen saver worked for my device, also.
MODEL: 4800X-Roku Ultra
SN: X01000H776T1
Software: 11.5.0 build 4225-C2
Device ID: S02A213776TT
Use the Roku remote to turn off tv.
Same issue as the rest.
4800X Roku Ultra
X010002C02GA
11.5 4235-C2
S02A20DC02GA
Hi everyone,
Thanks for the posts.
I have passed along your concerns and details to the appropriate Roku team to investigate further.
Thanks,
Danny
Light stays on for me, too, and I did check the auto-off setting is still on!
model Express 4K+
sn S07P219W7C9W
display type automatic (1080p)
software version 11.5.0 build 4235-CR