HDCP errors are constant and frequent, but intermittent.
I looked at this post: https://community.roku.com/t5/Solving-playback-issues/OS-10-5-HDCP-Error-need-assistance/m-p/664797
Nothing there solved my problem. I have a large set up with many different streaming and HDMI devices all connected through an HDMI switch or through a high end Demon AV amp.
I recently upgraded my Roku to a model 4802X (running 12.0.0, build 4184-C2) and very regularly, especially it seems more often as time goes by, the screen will go black momentarily, then the HDCP warning message will appear, it will go black for a second or two, the message reappears and then it starts working again just fine. I have tried dozens of different cables. I have tried connecting directly to the TV and two different video projectors with no devices in between, and the problem does not go away. I am not running 4K or HDR on any input or output, as my current displays are 1080p. I even borrowed a 4K projector and it too has the same results. Intermittent warnings about an HDCP error.
I am ready to toss this POS through a window it is so aggravating. I do NOT see these warnings or shutdowns with my older Roku device (non 4K), nor any other HDMI devices I own that use HDCP such as Blu-Ray players or my Dish set top box. They all perform perfectly.
OK Roku, you were a total fail on following through with your promise to replace my bad remote. What promise will you fail on my here? Should I just toss this player and assume I wasted my money on a defective device and remote? So far, that seems to be the case. I could use some assistance on solving this problem, and it makes the player mostly useless.
Does this seem to correspond to when your programming switches into, out of, or between programs or commercials?
Under "Settings > System > Advanced system Settings > Advanced display settings" does your Roku have an "Auto-adjust display refresh rate" item? If you don't have this setting, the rest of this post doesn't apply to you.
If this is enabled, the Roku circuitry sends the signal output at the refresh rate (frame rate) used by the original source material, commonly 24 fps (frames per second), 25 fps, 30 fps, 50 fps, or 60 fps. Every time the source frame rate changes, the TV must adjust its display to accommodate the new frame rate, which on many sets results in a short blackout. I've not seen your HDCP error reported as part of this transition, but it does sound plausible.
This can happen when starting/stopping new programs, and when going in/out of commercial breaks that have a different native frame rate than the programs they are inserted into.
If "Auto-adjust display refresh rate" is set OFF, or if your Roku does not have this option, Roku converts everything to a frame rate of 60 fps and the TV doesn't have to adjust on the fly.
The tradeoff here is that movement of things on the screen for non-60 fps sources may not be as smooth with no refresh rate adjustment, depending on whether your Roku or your TV does a better job of refresh rate conversion. You have to decide whether this change is worth it to you.
