Just bought a new roku express 4k with the simple remote. Got everything plugged in following the manual. Got to the language screen and then started putting in my Wi-Fi info. After typing one letter in everything stopped working. Now my roku is stuck on the language screen and doesn’t respond to the remote. Please help
Unplug the Roku device from power, plug back in, and allow it to reboot. Also, try using wall power if you are currently using the TV USB port for power. (if the device did not come with a wall adapter, try using a cell phone charging adapter 5volt 1amp). Sometimes I have to mess with the batteries and give a remote a few thumps in my hand when it stops working.
Tried everything. Different usb ports. Plugging into the wall, rebooting the system, giving the remote a good whack. Still nothing. Not a single bit of hope for it
Last thing to do is try a Factory Reset of the device.
Press and hold in the Reset button on the Roku device for 30+ seconds.
If still a no-go, you may have a defective device.
I've had the same problem with 2 of them. Technical support said to get a 3rd one. I think they are just junk,
I had the same problem, had it replaced, same problem. so I figured it was a generic problem. If I put the remote _right_ up to the roku, it works. So I opened the remote. There is a design/build issue in the remote in that the IR LED's are being damaged. There is a 0 OHM resistor that should be a 25 OHM to protect the LED. I replaced the LED and the resistor, it works fine now.
I have seen some people postings about working for a while, then suddenly losing distance, I'm sure it is the same problem.
ROKU needs to recall all of those simple remotes and fix the problem.
Make sure you are using the Roku remote to move past this screen not your tv remote .