Discussions

[Sunshine232]

Don’t attach tv ok first use a drill gun gently screw in and then reverse to remove ok and then set your tv align everything up and then try screw driver or gun ! Everyone said to do this screw and unscrew and screw again I did it and it worked ok !! Give it a go ! Watch tv not to scratch it get help !

[thaliarodriguez]

Thank you, we tried that. The screws go in only so far and we can't get them in any further. We keep taking them out and screwing them back in and they still won't go in all the way. 

[Sunni]

I solved the problem.  I used my drill to predrill the holes.   I tested the screws in each one after predrilling.  Then I attached the base and screwed the screws in tightly.  It is now fine.  Zero wobbles.  

[bipbop13]

What worked for me was to take just the screws, and screw them in to the base of the TV. When they had fully tightened up, I took them back out, placed the leg in and then put the screws in again. It worked, and the legs are nice & tight. Sometimes instructions are too vague, and a little Maine ingenuity & imagination helps make it all right.