Features, settings & updates

[DallasMaverick8]

Thank you sir!

You might be on to something, because after the factory reset it had large tiles in the main navigation and everything was working.

Within the next 24 hours, it magically updated to smaller tiles and then it stopped working.

[DallasMaverick8]

Good news, looks like it is working again!

Prayers have been answered by Roku.

[DanUK]

I had a similar issue with Roku pushing out an update yesterday on my Roku 4k Streaming stick 3810X.  It stopped the Roku remote from working and would not pair with it or other remotes in my household.

I was able to get into the device with the Roku phone App but only after turning off wifi isolation mode.

Rest assured I am going to install Wireshark into my router and I will figure out the IP and domains from where these updates are provided, they will be blocked from my router which has OpenWrt firmware.

I will soon be installing adware blocking, there has been a lot of discussion about blocking YouTube ads after they made onerous changes to skip and try to trick you by saying you can skip in 6 seconds only to flip it to 50 seconds when the 6 seconds expire.

Roku 4k Streaming stick 3810X is still damaged as it will not pair normally since it forced Software version 13 Build 24298.

As you say, a factory reset is really onerous to have to perform with all your apps and preferred settings that you have to disable because you don't want Roku's screensavers, what to watch, save list or other pollution.

[legorik27]

I know this thread is almost a year old however, I just recently had this happen at my own home.  I found that going into; settings, advanced system settings, control by mobile apps, network access- selecting enabled(which accepts all command on private network connections) fixed the issue for me.  It was on limited when I went there initially.  Switched to enabled and it worked instantly.

[Mastor_13]

I realize this is an older thread but figured I would add for others that on Jan 14, 2025 version 14.1 just hit my Roku 3 and the Control4 remote has stopped working.

might try factory reset… worried about what that could further screw up.

[Mastor_13]

This worked!  Thanks, I did not do a factory reset either, just enabled control by remote apps as you suggested.