Indoor Camera won't reset. Worked fine before update
My indoor camera stopped working so I attempted to factory reset it by holding down the setup button however, when doing so, the red light never blinks. Instead, it stays solid. It's as if the camera is completely non responsive. The setup button does absolutely nothing. When I turn it on, the camera light is red and stays solid until I unplug it.
I have tried all of the standard suggestions such as holding the setup button for 10 seconds. I actually tested holding it for up to a minute as well and nothing happened.
I tried unplugging it and waiting for a couple hours.
I tried pressing the setup button 5 to 10 times.
Tried a different power cord and outlet.
I have tried everything. The camera worked fine until the last update. My other camera still works but even that one has become delayed since the last update.
Also, for the camera that is working - there use to be a timer before the update that would show seconds counting and that's no longer on my viewer. Again, after the update, this camera will stop streaming however the screen shows that it's Live but I'll only know when I see a car drive by and nothing happen on my viewer. With the timer, I could at least see that the clock was moving alluding to it being live.
Super bummed. I used to brag about these cameras. They were so good and everything worked flawlessly. What is going on?
