Forum Discussion
8 Replies
- TivoburkeeCommunity Streaming Expert
The white directv remotes add an extra signal to every command, it may make the IR unrecognizable to the 75". Where the 55" isn't as sensitive to signals it accepts. Try the following steps:
1. tv
2. press and hold MUTE & SELECT for two blinks, release
3. enter 1 2 0 4 9
To enable the input key:
1. tv
2. press and hold MUTE & SELECT for two blinks, release
3. enter 9 6 0
To disable the extra signal:
1. tv
2. press and hold MUTE & SELECT for two blinks, release
3. enter 9 6 3
4. press CH down
- Dean42MVGChannel Surfer
Thank you.
I will try when I get home. I swear I've tried every code, but that code does not ring a bell !
[nor do the additional tips]
I'll report back !!
- Dean42MVGChannel Surfer
It WORKED !!
THE THING THAT I NEEDED TO DO WAS RESET THE REMOTE BACK TO RF MODE.
After that, I did the first two steps you suggested and it worked fine!!