Roku Express will not connect to internet with T-mobile hotspot
Does that mean that YOU DID FINALLY get the Roku EXPRESS to CONNECT??PLMK š¤
Forum Discussion
7 Replies
Replies have been turned off for this discussion
Hi HJakubs,
Thanks for reaching out here in Roku Community.
We do not have enough details based on your post. Are you having an issue connecting your Roku device to the network? Do you receive an error message or code? Kindly specify if there's any issue you are experiencing.
With more details, we can assist you further.
Regards,
NimfaYes. Have a mobile hotspot that I want to use an y internet connection. It finds my hotspot but won't connect. Only one green ā then a red x. Throws a 0009 code. I have already switched it to 2.4 hz in configuration but still no success connecting. the Roku EXPRESS Able to connect to a mobile hotspot?? Thx in advance
My phone/mobile hotspot says Im connected to roku... But Roku keeps saying there's a connection 0009 problem. I've restarted it and it hasn't changed anything
Please advise I'm ready to just go get my money back. It shouldn't be this challenging smh
In your phone's Settings, look for your APN (Access Point Name), and verify that IPv4 is enabled. Most mobile hotspots will be configured for IPv4 and IPv6. (IPv4/IPv6).
Roku does not currently support IPv6, so will need to at least have the IPv4 showing in these settings for Roku to access the internet. If only IPv6 is enabled, this is the likely culprit of your 009 (no internet error).
On T-mobile hotspot devices (not the mobile hotspots, but the actual home hotspot devices), some are currently having issues even when IPv4/IPv6 is enabled, so the fix for that is to just use IPv4-only when using with Roku devices.
On Androids, the APN is generally located under Settings/More/Cellular Networks/Access Point Names/[then click on the listed APN to Edit and view]. Then look under the APN Roaming protocol to see what IP protocols are being used. (this is where you should see IPv4/IPv6).
Depending on carrier, some mobile hotspots can be edited, some cannot. If yours are all greyed out on your phone, call the carrier and see what they can do. If you can edit them, then enable IPv4. Alternatively, just create a new APN with the exact settings of the existing one, and of course, enable IPv4. (Essentially, you are just cloning the original APN).
----
See if the above if your issue. If it is not, I would change the password in the hotspot, and then make sure to enter the new password correctly in the Roku network screen. Alternatively, in the Roku, go to Settings/System/Advanced System Settings/Network Connection Reset/Reset Connection. Then when the Roku device reboots, enter this new password.
Yes, by "copying" one of the profiles, selecting and then modifying the profile as described earlier in this thread.Pretty sure "profile" was the correct term, it's been about a year now. Another point I recall was hotspot configuration wasn't particularly user-friendly, the user interface is a little unconventional.
Logging into your hotspot configuration web page interface for the 1st time, it requires you to change the password from the factory default.
So grab a computer that's connected to your hotspot network, open the web browser application and navigate to your hotspot's configuration web address. From there, you have to create a new password if not already done before you can change any hotspot configuration settings.
You're looking to change the hotspot APN configuration as described in this thread.
I had other devices that couldn't access the hotspot wifi as well and by making this change to the hotspot APN "profile" those devices were also finally able to reach the internet.
So the problem isn't the roku device or other devices attempting to access the hotspot, the problem is the hotspot won't allow the connection.
